📞 +1 877-742-2878


Oberdorfer N9000R Bronze Gear Pump, NO MOTOR


Regular Price: $1,014.00

Sale Price $980.48

Oberdorfer N9000R, max flow 23 gpm, inlet size 1 in, NPT inlet/outlet connection type, Packing seal type, 3.7 horsepower, Yes relief valve. Motor NOT Included
Burt Process is an AUTHORIZED DISTRIBUTOR of this product.

Product images shown are for illustration purposes only 
and may not be an exact representation.

Notes N9000R Bronze Pedestal Gear Pump, Bare Shafted Pump End, Bronze Gears, SS Shaft, Packing Ring Seal. Inlet Port Is 1 Inch NPT, Discharge Port Is 1 Inch NPT
Weight (lbs) 12.4
  • Pump housings and gears are made of top quality bronze, shafts are 303 stainless steel. Bearings are made of high performance carbon-graphite material selected for wear resistance and long service life. Gear pumps are positive displacement pumps. Each shaft revolution displaces a definite amount of liquid relatively unaffected by the backpressure in the discharge line. Shaft speed and flow are directly proportional.

    The pump by-pass is not intended to be a metering or flow control device. Its main purpose is to function as a pressure relief when the desired set point is exceeded, overheating can occur within 5 -10 minutes if the discharge line is completely shut off for extended periods. Reversing rotation reverses the “IN” and “OUT” ports and the location of the by-pass ports have to be reversed. The by-pass valve is factory set at 50 p.s.i. To increase the set point, turn the bypass valve adjusting screw in a clockwise direction.

    • Bronze Corrosion Resistant Castings
    • Special Cast Bronze Gears
    • Stainless Steel Shafts & Fasteners
    • Formed Ring Seal Packing (Lip & Mechanical Seals on Special Order)
    • Heavy Duty Carbon Bearings (Self Lubricating)
    • Positive Displacement Flow

    Either direct drive with flexible coupling or pulley drive can be used. Make sure both flexible coupling halves are properly aligned. When using a pulley, do not over tighten the belt. Also, to absorb belt side thrust at higher pressures and larger size pumps, an external ball bearing support is recommended -- consult factory.


    Service life will be increased substantially if the liquid pumped is clean and has some degree of lubricity. These positive displacement pumps have tight tolerances. Fine abrasives like sand, silt, or powders in suspension will accelerate pump wear and reduce throughput. Liquids compatible with bronze and stainless steel can be pumped providing proper seal has been specified (see chemical compatibility or check factory). When possible, flush the pump after each usage. Temperature extremes are detrimental to service life and should be avoided. Basic metals of construction allow a temperature range of -40 to 400oF. Some lip and mechanical seal elastomers have a limit of 212oF. (see engineering data or check factory). Allowing a liquid to freeze in the pump can cause damage.


    Close tolerances and the positive pumping action make the rotary gear pump capable of lifting water on the suction side as high as 20 feet. Though gear pumps are self priming, a foot valve is recommended. If possible, wet the gears with liquid to be pumped for the first dry start. Liquid retained in the system and gear chambers serves to “wet” the pump on subsequent starts.

    *For pressures over 100 psi, the above selections are suitable for pumping fluids with lubricity (e.q. oils, polymers). Service life will decrease for fluids without lubricity (e.q. water, solvents).