📞 +1 877-742-2878
Product images shown are for illustration purposes only
and may not be an exact representation.
Weight (lbs) | 2 |
---|
The general purpose ultrasonic level sensor provides continuous level detection up to 26.2' (8m) with 3 programmable relays for level switch or control functions, and a 4-20mA signal output. The sensor is programmed via the integral push button display module. Each relay can be configured on a single set point (high level alarm or low level alarm) or latched on two set points for automatic fill or empty in simplex (one pump or valve), duplex (two pumps) or triplex (three pumps) level control modes with selectable time delay and fail-safe logic. The embedded level controller can lower cost by replacing external control hardware. This non-contact liquid level sensor is ideally suited for corrosive, sticky or dirty liquids, and is broadly selected for pump lift station, sump and day tank level applications.
Brand | Flowline |
---|---|
Product Type | Sensor |
Material - Housing | PVDF |
Max Temperature | 140°F (60°C) |
Max Pressure | MWP = 30 PSI (2 bar) |
Voltage | 95-250 VAC |
Enclosure | NEMA 4X (IP65) |
Power Requirements | 20 watts @ 120 VAC |
Approvals | CE |
Beam Width | LU77: 2in |
Conduit Entrance | Dual, 1/2 in |
Contact Rating | 2A, 30 VDC 60W (DC), 125 VA 220 VDC, 250 VAC |
Contact Type | Relay 1, SPDT relay, Relay 2 & 3, SPST, N.O. (All commons connected together) |
Dead Band | 8 in (20 cm) |
Display Type | Level and relay status, 6 character |
Enclosure Hardware | Brass & stainless |
Enclosure Material | Polycarbonate |
Gasket Material | Viton |
Sensor Range | 8 m (26.2 ft) |
Signal Excitation | 12 to 28 VDC, required |
Signal Fail-Safe | 4mA, 20mA, 21mA, 22mA or hold last |
Signal Output | 4-20 mA, two-wire, isolated, sinking |
Range | 26.2 ft (8 m) |
Process Mount | 2 in NPT |